RCBS RASS Shade Canopy - Manual (Page 5)

Open the Shade Canopy.
WARNING: BEFORE USING, BE SURE BENCH LEGS ARE FULLY EXTENDED AND FOOT LEVELERS ARE ADJUSTED
TO PLACE THE BENCH IN A STABLE AND LEVEL POSITION. FAILURE TO COMPLY WILL RESULT IN AN UNSAFE
FIREARM CONDITION THAT MAY CAUSE PROPERTY DAMAGE, PERSONAL INJURY OR DEATH.
WARNING: NEVER LEAVE FIREARM UNATTENDED ON FIREARM REST. FAILURE TO COMPLY WILL RESULT IN AN
UNSAFE FIREARM CONDITION THAT MAY CAUSE PROPERTY DAMAGE, PERSONAL INJURY OR DEATH.
TO USE
Once your R.A.S.S. Bench has been properly staked down and the Shade Canopy installed, you simply adjust the height of the
canopy and the angle, to block the sun.
To tilt the Shade Canopy 45 degrees, slide the Locking Sleeve upward and tilt the Canopy, release the Locking Sleeve.
Rotate the Canopy so that the lowest part is at your back when seated. Loosen the Knob and adjust the height of the Canopy to
suit your needs, re-tighten the Knob.