Bravetti EP559V2 - Manual (Page 4)

Caution : Always hold the hand
mixer with your hand while
processing. Do not leave the
appliance unattended when plugged
in.
Do not use to chop very hard foods
such as coffee beans or nutmeg.
Use for hard cheese, carrots, onions,
tomatoes, parsley, etc.
Important : To mince meat, cut the
meat into 1" cubes and do not mince
more than 200 grams (7 ounces) at
once. Make sure the meat is fully
defrosted and all bones and gristle
have been removed.
Always allow cooked food to cool
before placing in the chopping bowl.
The anti-skid base can also be used as
a cover for the chopper bowl.
Note: The processing time required
depends upon the type and quantity of
food to be processed and on the
degree of fineness you require. Meat
(200 grams/7 ounces - 1 inch cubes),
hard cheese (100 grams/3 1/2 ounces -
1 inch pieces) and carrots (150 grams/5
1/4 ounces - cut in pieces) usually
would require approximately 15
seconds. Onions (quartered) require
approximately 5-10 seconds. Parsley
(stems removed) approximately 15-20
seconds.
Insert drive
shaft in
small hole
Drive Shaft
5
OPERATING INSTRUCTIONS cont.
CHOPPER:
Make sure that the unit is unplugged
from power source and speed control
switch is on ”0" before inserting or
removing the chopper attachment.
Warning: Use extreme caution-
blades are sharp. Always hold the
chopper blade by the spindle.
1. Remove the blade cover from the
chopper blade.
2. Place the blade support into the
chopping bowl ensuring that the
locator pins are engaged.
3. Put the blade assembly on the
blade support of the chopper
bowl .
4. Place the chopper bowl on the anti-
skid base (bowl cover).
5. Place the food to be chopped in the
bowl.
6. Position the gear box on the
chopper bowl, fitting the grooves on
the gear box and bowl so that they
engage the bowl.
7. Insert the gear box drive shaft
into the corresponding opening on
the bottom of the hand mixer until
the gear box is securely locked in
place.
WARNING : This appliance is
designed for intermittent use.
Maximum running time with chopper is
3 minutes. After 3 minutes, allow the
unit to cool.
6
OPERATING INSTRUCTIONS cont.
ICE CRUSHING:
Caution: Always unplug the unit
from power outlet before changing
or assembly of accessories.
1. Place the blade support and the
chopping blade into the chopping
bowl.
2. Add ice to be crushed. Do not
attempt to chop more than four or
five ice cubes at a time.
3. Install the gearbox as per chopping
instructions on page 4.
4. Plug the unit into the power outlet.
5. Firmly hold the chopping bowl with
one hand while momentarily
depressing the power switch on the
main unit. Do not run the unit
continuously for more than 4
seconds at a time when crushing
ice. Use short bursts of power.
CLEANING & MAINTENANCE:
• Make sure that the unit is switched
“OFF” and disconnected from
power outlet before cleaning.
• Never immerse the hand mixer or
power cord in water or any other
liquid.
• Beaters, Dough Hooks and
Whisk: Eject beaters, dough hooks
and whisk from mixer and wash in
warm soapy water as soon as
possible after use before foods set
and dry. Rinse and dry after
washing. Beaters, dough hooks and
whisk can be washed in dishwasher.
• Stick Blender Attachment: Use
caution - blade is sharp. Detach
stick blender from mixer and wash
with warm soapy water. Do not use
any sharp objects to clean residue
under the blade, as this may
damage the housing. Do not wash
in dishwasher.
• Chopper Attachment: Use extra
caution when handling the chopping
blade. Always hold by the spindle.
Do not immerse the gear box in
water.
• Clean the stand with warm soapy
water.
• The hand mixer unit, power cord
and gear box should be wiped with
a damp cloth and then dried
thoroughly.
• Chopper blade, blade support,
chopper bowl, beaker and anti-skid
base/lids can be put in the
dishwaser.