Reloop NEON - VirtualDJ 8 Operation Guide - Manual (Page 9)

VirtualDJ 8 – Reloop NEON 9
Slicer mode
Press the SLICER mode button to set the PADs to Slicer mode.
The eight pads represent eight sequential
beats
—"Slices"—in the Beat Grid. The
playing Slice is represented by the
currently green lit pad. The green light will
"move through the pads" as it progresses
through each eight-Slice phrase. Press a
pad to repeat that Slice (hold it down if you
want to keep looping it).
Once the Pad is released the track will
continue to play from the position it would
have been if the pad was never pressed.
Hold SHIFT down and then use Pads 1 and 5 to increase/decrease the step of the Slicer
and Pads 4 and 8 to increase/decrease the length of the applied loop on the slice.
Slicer Hold mode
While the Slicer mode is selected, press the same SLICER mode button again to set the
PADs to Slicer Hold mode (led will blink).
In this mode the pads offer the same
functionality as in the Slicer mode, but in
this case, the Slice is memorized on first
press as the track continues to play.
(HOLD mode).
The playing Slice is represented by the
currently magenta lit pad.
Same as in Slicer mode, hold SHIFT down
and then use Pads 1 and 5 to
increase/decrease the step of the Slicer
and Pads 4 and 8 to increase/decrease the
length of the applied loop on the slice.