Reloop KEYPAD - BITWIG Setup Guide v1.0 - Manual (Page 3)

v 1.0
BITWIG SETUP GUIDE
RELOOP – KEYFADR
GLOBAL
S A1-A8 Mute Track.
S B1-B8 Solo Track.
S C1-C8 Arm Track.
S C4 + Shift Toggle Loop.
S C5 + Shift Tap Tempo.
S C6 + Shift Toggle Metronome.
S A1-A8 + Shift Launch Scene.
Octave up/down + Shift Scroll scenes up/down.
Play Toggle transport play/pause.
Stop Transport stop/go to start.
Record Toggle transport record.
Stop + Shift Stop all clips.
Record + Shift Toggle record overdub.
SCENE 2/DEVICE MODE
E 1-8 Device: Macros.
K A1-A8 Device: Common parameters.
K B1-B8 Device: User parameters.
F 1-8 Device: Envelope parameters.
S C1 + Shift Device: Next user parameter page.
S C2 + C3 + Shift Select previous/next cursor device.
S C7 + C8 + Shift Select previous/next cursor track.
SCENE 1/MIX MODE
E 1-8 Track Pan.
K A1-A8 Track Send 1.
K B1-B8 Track Send 2.
F 1-8 Track Volume.
S C7 / C8 Scroll Track Bank up/down.
IMPORTANT NOTE
For the script to work, you need to set the
KeyPad to Preset 2 by unplugging the USB
cable and then holding channel button 2 (S
A2) while plugging the USB cable back in.
To set the controller to use external sync
for the arpeggiator and run in sync with
Bitwig Studio, unplug the USB cable, then
hold down the ARP button while plugging
the cable back in.
Now channel buttons 1 and 8 (S A1 + A8)
should light up. Press channel button 8 (S
A8) for external sync.