Replay XD XD720 - Manual (Page 5)

1. Find the best mounting location for your Replay XD720 and check your angles.
Rigid surfaces are ideal for the best video quality. Note: You can make a test recording and check
it on an iPad/Mac/PC.
2. Snap Replay XD720 into u-shape camera holder and rotate 360º to desired rotation.
3. Attach VHB SnapTray adhesive mount to a clean smooth surface.
-Flat SnapTray’s are good for flat smooth surfaces.
-Curved SnapTray’s are good for curved surfaces such as Helmets & Radius surfaces.
The 3M VHB adhesive is not recommended for textured surfaces.
4. Slide HeimLock mount into SnapTray until it is fully seated and clicks.
5. Adjust swivel 360º or tilt ~8º by releasing the heim cam lever and position Replay
XD720 in desired direction, then lock the cam lever. Make sure the cam lever is tight.
There is an adjustable tension wheel and phillips screw (*) to make sure you always have
a positive tight lock. You can tighten the screw clockwise in 1/4 turn increments to find
the desired tension when the cam lever is locked.
H EI M LO CK M O U N T See our full range of mounts at www.Replayxd.com
*
VHB SnapTray HeimLock Mount
Unlock
Lock
Tighten
Set screw
Tilt Swivel
IMPORTANT
Use rubbing alcohol to clean
the mounting surface. Wipe
dry the surface. Apply your
VHB mount to surface. Press
and hold for sixty seconds to
allow adhesive to bond to
the surface. Bond strength
will increase through time.
At room temperature,
wait for at least 24 hours
to achieve 90% bonding
strength, and 72 hours for
100% bonding strength.