Optimizing performance, Continued on next page), Figure 13: horizontal bi-amplified connections – Revel C32 User Manual
Page 17
17
OPTIMIZING
PERFORMANCE
To optimize the C32 for best performance:
1. When the C32 is connected, set the
High Frequency Level identified in
Figure 3 (page 7) control to 0. (Different
listening rooms may require other High
Frequency Level control settings.)
2. Set the associated multi-channel
controller or receiver for an 80Hz
crossover (or higher), even if the
loudspeaker setup does not include a
subwoofer. In its absence, the associated
multi-channel controller or receiver
will use bass management to route
frequencies below 80Hz to the front left
and right channels, without losing
center-channel low-frequency
information.
(continued on next page)
C32
On Top Of
Monitor
Flush
Mounted
Stand
Mounted
Placement
Compensation
Low Frequency Input
Remove straps
for bi-wire
or bi-amp
High Frequency Input
High Frequency
Level (dB)
Revel
Northridge, California
Assembled in U.S.A.
Serial No.
-1
+1
+.5
-.5
0
OUTPUT 1
POWER
AMPLIFIER 1
OUTPUT 1
POWER
AMPLIFIER 2
Figure 13: Horizontal Bi-Amplified Connections