Carbine PLUS 6850 - Manual (Page 12)

12
Dome Light Supervision
The Security System has a unique feature for using your vehicle’s dome light:
1. Upon disarming the vehicles security system, the interior dome light will remain on for 30
seconds.
2. If the security system is triggered, the dome light will flash for the same duration as the
horn/siren.
Note: Turn “ON” the ignition switch or arm the system to turn off the dome light.
Ignition Controlled Door Locks
If the vehicles door locks have been interfaced with the security system, the system will
automatically lock the doors when the ignition is turned “ON”, or unlock the doors when ignition
key is turned “OFF”.
Trunk Release Output (Channel 3)
Press and hold the button for two seconds to activate the trunk release (Channel 3 output)
and/or any other devices connected.
Timer Control Output (Channel 4)
Press and hold the and button at the same time to activate the Channel 4 output. Channel 4
is user programmable timer output. You may program the built-in timer to send a ground signal
for any time duration from 1 second to 120 seconds. For example, this timer output may be used
to turn on the headlights, power window or sunroof (Factory defaults setting at momentary
output.)
Out-of-Range Indication
If the Out-of-Range Indication feature is activated the system will automatically check the range
every 30 minutes after armed.
1. If the user is within the range, the icon will display on the LCD screen.
2. If user is out of range, the icon will disappear from the LCD screen and the transmitter will
beeps 5 times.
Note: Activating this feature will decrease the life expectancy of battery.
Driver Paging / Lost and Found
(For LCD transmitter only)
Driver Paging / Lost and Found is useful the event that someone wants to page
the driver of the parked vehicle, or someone cannot find the LCD transmitter.
With the ignition switch in the “OFF” position, press and hold the valet switch for
2 seconds to page the driver. One chirp shall be emitted and the paging melody
continues sounding from the LCD transmitter and will flash on the screen.
Power-On Memory
This security system is equipped with circuitry that will allow the unit to remember its alarm state
if the power is lost and then reconnected.
PLUS-6850-UM 12/27/06 9:07 Page 12