Rite-Ride 2423 - Manual (Page 4)

Select a location on the vehicle for the air inflation valves. The location can be on the bumper or the body of the
vehicle, as long as it is in a protected location so the valve will not be damaged, but maintain accessibility for the air
chuck (see Figure "B"). Drill a 5/16" hole and install the air inflation valve using two 5/16" flat washers per valve
as supports (see Figure "C"). Run the tubing from the air helper spring to the inflation valve, routing it to avoid direct
heat from the engine, exhaust pipe, and away from sharp edges. Thermal sleeves have been provided for these
conditions. If a thermal sleeve is required simply slide the sleeve over the air line tubing to the location requiring
protection. The air line tubing should not be bent or curved sharply as it may buckle.
Secure the tubing in place with the nylon ties provided. Push the end of the air line tubing into the inflation valve
as illustrated, see Figure "C".
STEP 6 - CHECK THE AIR SYSTEM
Once the inflation valves are installed inflate the air helper springs to 70 psi. and check the fittings for air leaks
with an applied solution of soap and water. If a leak is detected at a tubing connection then check to make sure that
the tube is cut as square as possible and that it is pushed completely into the fitting. The tubing can easily be removed
from the fittings by pushing the collar towards the body of the fitting and then pulling out the tube. If a leak is detected
where the brass elbow fitting screws into the spring, remove the tubing (see trouble shooting section of the operating
instruction manual for removal procedure),then screw the elbow into the spring one additional turn or until the leak
stops. Reinstall the tubing and reinflate the air springs and check for leaks as noted above.
This now completes the installation. Install the wheels and torque the lug nuts to the manufactures specifications.
Raise the vehicle by the rear axle and remove the jack stands and lower the vehicle back onto the ground. Re-attach
the negative battery cable and remove the wheel chocks from the front wheels. Before proceeding, check once again
to be sure you have proper clearance around the air springs. With a load on your vehicle and the air helper springs
inflated, you must have at least 1/2" clearance around the air springs. As a general rule, the air helper springs will
support approximately 40 lbs. of load for each psi. of inflation pressure (per pair). For example, 50 psi. of inflation
pressure will support a load of 2000 lbs. per pair of air helper springs. FOR BEST RIDE use only enough air pressure
in the air helper springs to level the vehicle when viewed from the side (front to rear). This amount will vary depending
on the load, location of load, condition of existing suspension and personal preference.
NOTE:
Too much air pressure in the air helper springs will result in a firmer ride, while too little air pressure will allow
the air helper spring to bottom out over rough conditions. Too little air pressure will also not provide the
improvement in handling that is possible. TO PREVENT POSSIBLE DAMAGE MAINTAIN A MINIMUM OF
5 psi. IN THE AIR HELPER SPRINGS AT ALL TIMES.
NOTE:
Once the air helper springs are installed, it is recommended that the vehicle not be lifted by the frame, as
over-extension may occur, resulting in damage to the air helper springs. However, should it become necessary to
raise the vehicle by the frame, deflate both air helper springs completely.
www.riderite.com
N
OTE
:
MIN PRESSURE 5 PSI
MAX PRESSURE (LOADED) 100 PSI