Rite-Ride 2025 User Manual

Rite-Ride For the car

Advertising
background image

2025

P

ARTS

LIST

I

NSTALLATION

I

NSTRUCTIONS

Congratulations - your new Air Helper Springs are quality

products capable of improving the handling and comfort of
your vehicle. As with all products, proper installation is the
key to obtaining all of the benefits your kit is capable of
delivering. Please take a few minutes to read through the
instructions to identify the components and learn where and
how they are used. It is a good idea to start by comparing the
parts in your kit with the parts list below.

The heart of the air spring kit is, of course, the air helper

springs. Remember that the air helper springs must flex and
expand during operation, so be sure that there is enough
clearance to do so without rubbing against any other part of
the vehicle.

Be sure to take all applicable safety precautions during the

installation of the kit. The instructions listed in this brochure
and the illustrations all show the left, or driver’s side of the
vehicle. To install the right side assembly simply follow the
same procedures.

Your kit includes separate inflation valves and air lines for

each air helper spring. This will allow you to level your vehicle
from side to side as well as from front to back. If you would
rather have a single valve inflation system, your dealer can
supply the required "T" fitting.

I

MPORTANT

!

For your safety and to prevent possible damage to your

vehicle, do not exceed the maximum load recommended by
the vehicle manufacturer (GVWR). Although your Air Helper
Springs are rated at a maximum inflation pressure of 100
P.S.I., this pressure may allow you to carry too great a load
on some vehicles. Check your vehicle owner’s manual for
maximum loads listed for your vehicle.

When inflating your Air Helper Springs, add air pressure

in small quantities, checking pressure frequently during
inflation. The air spring requires much less air volume than
a tire and, therefore, inflates much quicker.

WARNING:

Do not inflate this assembly when it is

unrestricted. The assembly must be restricted by
the suspension or other adequate structure. Do
not inflate beyond 100 P.S.I. Improper use or over
inflation may cause property damage or severe
personal injury.

AIR SPRING

6781

2

UPPER BRACKET

5178

2

LOWER BRACKET

5214

2

FRAME BRACE

5180

2

BRACKET CLAMP

5181

2

18 ft. TUBING

0938

1

PUSH-TO-CONNECT

INFLATION VALVE

3032

2

PUSH-TO-CONNECT

ELBOW

3031

2

21-8109

07-04

NCD-5547-7

3/8"-16 X 4" HEX BOLT

4

3/8"-16 FLANGE LOCK NUT

12

3/8"-16 X 3/4" HEX BOLT

2

3/8"-16 X 7" CARRIAGE BOLT

4

5/16" FLAT WASHER

4

HEAT SHIELD

1004

1

THERMAL SLEEVE

0899

2

NYLON TIE

6

A

Advertising