Rite-Ride 2528 - Manual (Page 2)

FIGURE “A”
LEAF SPRINGS
AIR
SPRING
UPPER
BRACKET
INSERT
ALIGNMENT PIN
3/8ʺ-16 X 2ʺ
FLATHEAD BOLT
NOTE: THE JOUNCE BUMPER CUP
STAYS ON THE FRAME AFTER THE
JOUNCE BUMPER IS REMOVED.
THE UPPER BRACKET FITS AROUND
THE JOUNCE BUMPER CUP.
NOTE: TALL LEG FACES
TOWARDS FRONT OF VEHICLE!
3/8ʺ-16 X 7ʺ
CARRIAGE
BOLT
3/8ʺ-16 X 5/8ʺ
FLATHEAD BOLT
BAIL
CLAMP
3/8ʺ-16 FLANGE NUTS
TO BAIL CLAMP
AXLE
3/8ʺ-16
FLANGE LOCK NUTS
The INSERT must be pushed into
the jounce bumper cup and then
twisted into place to capture the
flanges on the inside of the cup.
See Figure “B”.
NOTE: All illustrations are of the left
or driver’s side of the truck. Refer to
step 3 for proper lower bracket alignment.
BRACKET CLAMP
3/4ʺ-16
HEX NUT
3/4ʺ INTERNAL
TOOTH LOCK
WASHER
REAR