Cypress CY7C1333H - Manual

PRELIMINARY
2-Mbit (64K x 32) Flow-Through SRAM
with NoBL™ Architecture
CY7C1333H
Cypress Semiconductor Corporation • 3901 North First Street • San Jose , CA 95134 • 408-943-2600
Document #: 001-00209 Rev. ** Revised April 11, 2005
Features
• Can support up to 133-MHz bus operations with zero
wait states.
— Data is transferred on every clock.
• Pin compatible and functionally equivalent to ZBT™
devices
• Internally self-timed output buffer control to eliminate
the need to use OE
• Registered inputs for flow-through operation
• Byte Write capability
• 64K x 32 common I/O architecture
• Single 3.3V power supply
• Fast clock-to-output times
— 6.5 ns (for 133-MHz device)
— 8.0 ns (for 100-MHz device)
• Clock Enable (CEN) pin to suspend operation
• Synchronous self-timed writes Offered in Lead-Free
• Asynchronous Output Enable
• Offered in Lead-Free JEDEC-standard 100 TQFP
package
• Burst Capability—linear or interleaved burst order
• Low standby power
Functional Description [1]
The CY7C1333H is a 3.3V, 64K x 32 Synchronous
Flow-through Burst SRAM designed specifically to support
unlimited true back-to-back Read/Write operations without the
insertion of wait states. The CY7C1333H is equipped with the
advanced No Bus Latency™ (NoBL™) logic required to
enable consecutive Read/Write operations with data being
transferred on every clock cycle. This feature dramatically
improves the throughput of data through the SRAM, especially
in systems that require frequent Write-Read transitions.
All synchronous inputs pass through input registers controlled
by the rising edge of the clock. The clock input is qualified by
the Clock Enable (CEN) signal, which when deasserted
suspends operation and extends the previous clock cycle.
Maximum access delay from the clock rise is 6.5 ns (133-MHz
device).
Write operations are controlled by the two Byte Write Select
(BW
[A:D]
) and a Write Enable (WE) input. All writes are
conducted with on-chip synchronous self-timed write circuitry.
Three synchronous Chip Enables (CE
1
, CE
2
, CE
3
) and an
asynchronous Output Enable (OE) provide for easy bank
selection and output three-state control. In order to avoid bus
contention, the output drivers are synchronously three-stated
during the data portion of a write sequence.
Note:
1. For best-practices recommendations, please refer to the Cypress application note System Design Guidelines on www.cypress.com.
C
MODE
BW A
BW B
WE
CE1
CE2
CE3
OE
READ LOGIC
DQs
MEMORY
ARRAY
E
INPUT
REGISTER
BW C
BW D
ADDRESS
REGISTER
WRITE REGISTRY
AND DATA COHERENCY
CONTROL LOGIC
BURST
LOGIC
A0'
A1' D1
D0 Q1
Q0
A0
A1
ADV/LD
CE ADV/LD
C
CLK
CEN
WRITE
DRIVERS
D
A
T
A
S
T
E
E
R
I
N
G
S
E
N
S
E
A
M
P
S
WRITE ADDRESS
REGISTER
A0, A1, A
O
U
T
P
U
T
B
U
F
F
E
R
S
E
ZZ
SLEEP
Control
Logic Block Diagram
[+] Feedback