Rite-Ride 2220 - Manual

AIR SPRING 6781 2
UPPER BRACKET RIGHT 5198 1
UPPER BRACKET LEFT 5199 1
LOWER BRACKET RIGHT 5273 1
LOWER BRACKET LEFT 5274 1
LOWER BRACE RIGHT (L) 5271 1
LOWER BRACE LEFT (L) 5272 1
REAR BRACKET STRAP 1163 2
BAIL CLAMP 3077 2
HEAT SHIELD 1004 1
P-CLAMP 9179 1
1/4" -20 x 1" HEX BOLT 2
1/4" -20 HEX NUT 2
3/8" -16 x 1" HEX BOLT 8
3/8" -16 x 3/4" FLANGED HEX BOLT 2
3/8" -16 FLANGED HEX NUT 20
3/8" -16 x 3" CARRIAGE BOLT 4
18 FT. AIR LINE 0938 1
PUSH-TO-CONNECT
MALE FITTING 3046 2
INFLATION VALVE 3032 2
5/16" FLAT WASHER 4
THERMAL SLEEVE 0899 2
NYLON TIE 8
I NSTALLATION I NSTRUCTIONS
Congratulations - your new air helper springs are quality
products capable of improving the handling and comfort of your
vehicle. As with all products, proper installation is the key to
obtaining all of the benefits your kit is capable of delivering.
Please take a few minutes to read through the instructions to
identify the components and learn where and how they are used.
It is a good idea to start by comparing the parts in your kit with
the parts list below.
The heart of the air helper spring kit is, of course, the air
springs. Remember that the air helper springs must flex and
expand during operation, so be sure that there is enough
clearance to do so without rubbing against any other part of the
vehicle.
Be sure to take all applicable safety precautions during the
installation of the kit. The instructions listed in this brochure
and the illustrations all show the left or driver’s side of the
vehicle. To install the right side assembly simply follow the
same procedures while reversing any orientations.
Your kit includes separate inflation valves and air lines for
each air helper spring. This will allow you to level your vehicle
from side to side as well as from front to back. If you would rather
have a single valve inflation system, your dealer can supply the
required T-fittings.
I MPORTANT !
For your safety and to prevent possible damage to
your vehicle, do not exceed the maximum load recommended
by the vehicle manufacturer (GVWR). Although your Air
Helper Springs are rated at a maximum inflation pressure
of 100 psi, this pressure may allow you to carry too great a
load on some vehicles. It is best to have your vehicle
weighed once it is completely loaded and compare that
weight to the maximum allowed. Check your vehicle owner’s
manual or data plate on driver side door for maximum
loads listed for your vehicle.
When inflating your Air Helper Springs, add air pressure
in small quantities, checking pressure frequently during
inflation. The air spring requires much less air volume
than a tire and, therefore, inflates much quicker.
W ARNING :
Do not inflate this assembly when it is unrestricted.
The assembly must be restricted by the suspension or
other adequate structure. Do not inflate beyond 100
P.S.I. Improper use or over inflation may cause property
damage or severe personal injury.
P ARS L IST
21-8192 01-06 NCD-6149-2
2220
L
L