Rite-Ride 2565 - Manual

2565
02-14
INSTALLATION INSTRUCTIONS
Congratulations—your new Air Helper Springs are quality
products capable of improving the handling and comfort
of your vehicle. As with all products, proper installation is
the key to obtaining all of the benefits your kit is capable
of delivering. Please take a few minutes to read through
the instructions to identify the components and learn
where and how they are used. It is a good idea to start by
comparing the parts in your kit with the parts list below.
The heart of the air helper spring kit is, of course, the
air springs. Remember that the air helper springs must
flex and expand during operation, so be sure that there
is enough clearance to do so without rubbing against any
other part of the vehicle.
Be sure to take all applicable safety precautions
during the installation of the kit. The instructions listed
in this brochure and the illustrations all show the left,
or driver’s side of the vehicle. To install the right side
assembly simply follow the same procedures.
Your kit includes separate inflation valves and air
lines for each air helper spring. This will allow you to
level your vehicle from side to side as well as from front
to back. If you would rather have a single valve inflation
system, your dealer can supply the required “T” fitting.
IMPORTANT!
For your safety and to prevent possible damage
to your vehicle, do not exceed the maximum load
recommended by the vehicle manufacturer (GVWR).
Although your Air Helper Springs are rated at a maximum
inflation pressure of 100 psi, this pressure may allow you
to carry too great a load on some vehicles. It is best to
have your vehicle weighed once it is completely loaded
and compare that weight to the maximum allowed. Check
your vehicle owner’s manual or data plate on driver’s side
door for maximum loads listed for your vehicle.
When inflating your Air Helper Springs, add air pres-
sure in small quantities, checking pressure frequently
during inflation. The air spring requires much less air
volume than a tire and, therefore, inflates much quicker.
WARNING:
Do not inflate this assembly when it is
unrestricted. The assembly must be restricted
by the suspension or other adequate
structure. Do not inflate beyond 100 psi
Improper use or over inflation may cause
property damage or severe personal injury.
AIR SPRING 9055 2
UPPER BRACKET 5771 2
LEFT FRAME BRACKET 5701 1
RIGHT FRAME BRACKET 5700 1
LEFT LOWER BRACKET 5791 1
RIGHT LOWER BRACKET 5790 1
FRAME HOLE BRACKET 5660 4
BAIL CLAMP 4.5 X 2.5 X 2.0 3410 4
AIR LINE TUBING 18 FT. 1
INFLATION VALVE 3032 2
ELBOW FITTING 3048 2
3/8"-16 FLANGE LOCK NUT 16
3/8"-16 X 1" HEX HEAD BOLT 12
3/8"-16 X 1/2" FLANGE BOLT 4
M10 X 20 MM BOLT 2
5/16" FLAT WASHER 4
THERMAL SLEEVE 2
NYLON TIE STRAP 6
CAUTION TAG 2
PARTS LIST BOLT PACK (A21-760-2565)