Chauvet LXW - Manual (Page 8)

LXW User Manual 8 12/31/2008 4:21 PM
General Troubleshooting
Symptom Solution(s)
Applies to
Lights
Foggers
& Snow Controllers
Dimmers
& Chaser
Beam is very dim or
not bright Clean optical system or replace lamp
Check 220/110v switch for proper setting 
Breaker/Fuse keeps
blowing Check total load placed on device 
Device has no power Check for power on Mains.
Check device’s fuse. (internal and/or external)   
Fixture is on but
there is no
movement to the
audio Make sure you have the correct audio mode on the
control switches. If audio provided via ¼” jack, make
sure a live audio signal exists
Adjust sound sensitivity knob
  
Lamps cuts off
sporadically Possible bad lamp or fixture is overheating.
Lamp may be at end of its life. 
Moves slow Check 220/110v switch for proper setting 
No light output Check slip ring & brushes for contact
Install bulb
Call service technician

If you still have a problem after trying the above solutions, please contact CHAUVET Technical
Support at the location listed below.
Technical Support
Address: Service Dept.
3000 N 29th Ct, Hollywood, FL 33020 (U.S.A.)
Support (Email): [email protected]
Telephone: (954) 929-1115 - (Press 4)
Fax: (954) 929-5560 - (Attention: Service)
Website: http://www.chauvetlighting.com