Rite-Ride 2181 - Manual (Page 2)

Note: The kit assembly illustration shown to
the right is of the right, or passengers side,
of the vehicle. Reverse any orientations when
assembling the kit on the left, or drivers, side
of the vehicle.
DISK
(21-5204)
REAR
WHEEL
FIGURE "A"
LOWER BRACKET HOOK LOCATION
SHOULD CAPTURE THE “U”-BOLT TO THE
INSIDE OF THE LEAF STACK.
UPPER BRACKET
(21-5208/21-5209)
AIR FITTING
SEE NOTE 1
LOWER BRACKET
(21-5218)
AIR SPRING
110/70 (9000)
3/8"-16x3/4”
FLANGED
HEX BOLTS
3/8"-16x3/4”
FLANGED HEX BOLT
3/8"-16 x3- 1/2"
CARRIAGE
BOLT
K
i
t
a
s
s
e
m
b
l
y
DRIVERS SIDE
AXLE
FRONT
DRIVERS SIDE (left)
3/8”-16X1-1/2” HEX BOLTS
HOLES MUST BE DRILLED
3/8”-16x1-1/2” HEX BOLTS
EXISTING HOLES
ON SOME VEHICLES
( MAY REQUIRE DIAMETER INCREASE)
BRACKET STRAP
3/8”-16 FLANGE LOCK NUTS
EXISTING
NUT & STUD
JOUNCE
BUMPER
AXLE
FRONT
LOWER BRACKET HOOK LOCATION
SHOULD CAPTURE THE “U”-BOLT.
PASSENGERS SIDE (right)
3/8”-16x1-1/2” HEX BOLTS
HOLE MUST BE DRILLED
JOUNCE
BUMPER
BRACKET STRAP
3/8”-16 FLANGE LOCK NUTS
Note 1:
Elbow fitting may point in various
directions depending upon
inflation valve location.
Note 2:
Please take all necessary safety
precautions while installing your
Sport-Rite kit.
Kit to frame assembly
Use small flat washer
behind frame in this
bolt location.
3/8”-16x1-1/2” HEX BOLTS
EXISTING HOLES
ON SOME VEHICLES
( MAY REQUIRE DIAMETER INCREASE)