Rite-Ride 2061 - Manual

2061
21-8161 11-07 NCD-5991-3
I
NSTALLATION INSTRUCTIONS
Congratulations - your new air helper springs are quality
products capable of improving the handling and comfort of your
vehicle. As with all products, proper installation is the key to
obtaining all of the benefits your kit is capable of delivering.
Please take a few minutes to read through the instructions to
identify the components and learn where and how they are used.
It is a good idea to start by comparing the parts in your kit with
the parts list below.
The heart of the kit is, of course, the air springs. Remember
that the air helper springs must flex and expand during opera-
tion, so be sure that there is enough clearance to do so without
rubbing against any other part of the vehicle.
Be sure to take all applicable safety precautions during the
installation of the kit. The instructions listed in this brochure
and the illustrations all show the left, or driver’s side of the
vehicle. To install the right side assembly simply follow the same
procedures.
Your kit includes separate inflation valves and air lines for
each air helper spring. This will allow you to level your vehicle
from side to side as well as from front to back. If you would rather
have a single valve inflation system, your dealer can supply the
required "T" fitting.
I
MPORTANT
!
For your safety and to prevent possible damage to your
vehicle, do not exceed the maximum load recommended by the
vehicle manufacturer (GVWR). Although your air helper
springs are rated at a maximum inflation pressure of 100 P.S.I.,
this pressure may allow you to carry too great a load on some
vehicles. Check your vehicle owner’s manual for maximum
loads listed for your vehicle.
When inflating your air helper springs, add air pressure in
small quantities, checking pressure frequently during infla-
tion. The air spring requires much less air volume than a tire
and, therefore, inflates much quicker.
W
ARNING
!
Do not inflate this assembly when it is unre-
stricted. The assembly must be restricted by the
suspension or other adequate structure. Do not
inflate beyond 100 P.S.I. Improper use or over
inflation may cause property damage or severe
personal injury.
AIR SPRING 6764 2
UPPER BRACKET (LEFT) 5110 1
UPPER BRACKET (RIGHT) 5111 1
LOWER BRACKET 5156 2
BRACKET STRAP 0530 4
AIR LINE TUBING - 18 FT 0938 1
HEAT SHIELD 1004 1
3/8"-16 X 3" CARRIAGE BOLT 2
3/8"-16 X 3-1/2" CARRIAGE BOLT 8
3/8"-16 FLANGED LOCK NUT 18
5/16" -24 X 1" HEX BOLT 2
5/16" -24 FLANGED LOCK NUT 2
5/16" FLAT WASHER 6
PUSH-TO-CONNECT
INFLATION VALVE 3032 2
PUSH-TO-CONNECT
STRAIGHT FITTING 3046 2
NYLON TIES 6
THERMAL SLEVE 2
CAUTION TAG 2
P
ARTS
L
IST