Rite-Ride 2410 - Manual

P
ARTS LIST
I
NSTALLATION
I
NSTRUCTIONS
Congratulations - your new Air Helper Springs are quality
products capable of improving the handling and comfort of your
vehicle. As with all products, proper installation is the key to
obtaining all of the benefits your kit is capable of delivering.
Please take a few minutes to read through the instructions to
identify the components and learn where and how they are used.
It is a good idea to start by comparing the parts in your kit with
the parts list below.
The heart of the Air Helper Spring kit is, of course, the air
helper springs. Remember that the air helper springs must flex
and expand during operation, so be sure that there is enough
clearance to do so without rubbing against any other part of the
vehicle.
Be sure to take all applicable safety precautions during the
installation of the kit. The instructions listed in this brochure
and the illustrations all show the left, or driver’s side of the
vehicle. To install the right side assembly simply follow the same
procedures.
Your kit includes separate inflation valves and air lines for
each air helper spring. This will allow you to level your vehicle
from side to side as well as from front to back. If you would rather
have a single valve inflation system, your dealer can supply the
required "T" fitting.
I
MPORTANT
!
For your safety and to prevent possible damage to your
vehicle, do not exceed the maximum load recommended by the
vehicle manufacturer (GVWR). Although your Air Helper
Springs are rated at a maximum inflation pressure of 100 P.S.I.,
this pressure may allow you to carry too great a load on some
vehicles. Check your vehicle owner’s manual for maximum
loads listed for your vehicle.
When inflating your Air Helper Springs, add air pressure
in small quantities, checking pressure frequently during
inflation. The air spring requires much less air volume than
a tire and, therefore, inflates much more quickly.
AIR SPRING 6762 2
UPPER BRACKET 5502 2
LOWER BRACKET 5503 2
5/16" -24 U-BOLT 4
5/16" -24 FLANGED HEX NUT 8
3/8" -16 FLANGED HEX NUT 4
3/8" -16 x 3/4" FLANGED HEX BOLT 2
5/16" FLAT WASHER 4
21-8326 11-07 NAD-32336-1
W
ARNING
!
Do not inflate this assembly when it is
unrestricted. The assembly must be restricted by
the suspension or other adequate structure. Do not
inflate beyond 100 P.S.I. Improper use or over
inflation may cause property damage or severe
personal injury.
2410
AIR LINE TUBING, 18 FT. 1
PUSH-TO-CONNECT
ELBOW FITTING 3031 2
PUSH-TO-CONNECT
INFLATION VALVE 3032 2
NYLON TIE STRAP 6
THERMAL SLEEVE 2
CAUTION TAG 2