Rite-Ride 2116 - Manual

21-8106 09-07 NCD-5506-2
WARNING:
Do not inflate this assembly when it is unre-
stricted. The assembly must be restricted by
the suspension or other adequate structure.
Do not inflate beyond 100 P.S.I. Improper use
or over inflation may cause property damage
or severe personal injury.
2116
INSTALLATION INSTRUCTIONS
Congratulations - your new Ride-Rite Air Helper Springs
are quality products capable of improving the handling
and comfort of your vehicle. As with all products,
proper installation is the key to obtaining all of the
benefits your kit is capable of delivering. Please take a
few minutes to read through the instructions to identify
the components and learn where and how they are used.
It is a good idea to start by comparing the parts in your
kit with the parts list below.
The heart of the Ride-Rite kit is, of course, the air helper
springs. Remember that they must flex and expand
during operation, so be sure that there is enough clear-
ance to do so without rubbing against any other part of
the vehicle.
Be sure to take all applicable safety precautions during
the installation of the kit. The instructions listed in this
brochure and the illustrations all show the left or driver’s
side of the vehicle. To install the right hand assembly
simply follow the same procedures.
Your kit includes separate inflation valves and air lines
for each air spring. This will allow you to level your
vehicle from side to side as well as from front to back.
If you would rather have a single valve inflation system,
your dealer can supply the required "T" fittings.
IMPORTANT!
For your safety and to prevent possible damage to
your vehicle, do not exceed the maximum load
recommended by the vehicle manufacturer
(GVWR). Although your Ride-Rite Air Helper
Springs are rated at a maximum inflation pressure
of 100 p.s.i., this pressure may allow you to carry
too great of a load on some vehicles. Check your
vehicle owner’s manual for maximum loads listed
for your vehicle.
When inflating your Ride-Rite Air Helper Springs,
add air pressure in small quantities, checking
pressure frequently during inflation. The air spring
requires much less air volume than a tire and,
therefore, inflates much quicker.
PARTS LIST
AIR SPRING 6781 2
UPPER BRACKET 5174 2
LOWER BRACKET 5129 2
BRACKET STRAP 5103 4
18 ft. TUBING 1
3/8"-16 x 3" CARRIAGE BOLT 8
3/8"-16 FLANGE LOCK NUT 12
3/8"-16 x 3/4" HEX BOLT 2
5/16"-18 BAIL CLAMP 4
5/16"-18 FLANGE LOCK NUT 8
5/16" FLAT WASHER 4
ELBOW AIR FITTING 2
INFLATION VALVE 2
NYLON TIES 6
THERMAL SLEEVE 2
CAUTION TAG 2