Rite-Ride 2355 - Manual

2355
21-8298 10-09 NAD-34165-5
I
NSTALLATION INSTRUCTIONS
Congratulations - your new Air Helper Springs are quality
products capable of improving the handling and comfort of your
vehicle. As with all products, proper installation is the key to
obtaining all of the benefits your kit is capable of delivering.
Please take a few minutes to read through the instructions to
identify the components and learn where and how they are used.
It is a good idea to start by comparing the parts in your kit with
the parts list below.
The heart of the air helper spring kit is, of course, the air
springs. Remember that the air helper springs must flex and
expand during operation, so be sure that there is enough
clearance to do so without rubbing against any other part of the
vehicle.
Be sure to take all applicable safety precautions during the
installation of the kit. The instructions listed in this brochure
and the illustrations all show the left, or driver’s side of the
vehicle. To install the right side assembly simply follow the same
procedures.
Your kit includes separate inflation valves and air lines for
each air helper spring. This will allow you to level your vehicle
from side to side as well as from front to back. If you would rather
have a single valve inflation system, your dealer can supply the
required "T" fitting.
I
MPORTANT
!
For your safety and to prevent possible damage to your
vehicle, do not exceed the maximum load recommended by the
vehicle manufacturer (GVWR). Although your Air Helper
Springs are rated at a maximum inflation pressure of 100 psi,
this pressure may allow you to carry too great a load on some
vehicles. It is best to have your vehicle weighed once it is
completely loaded and compare that weight to the maximum
allowed. Check your vehicle owner’s manual or data plate on
driver's side door for maximum loads listed for your vehicle.
When inflating your Air Helper Springs, add air pressure
in small quantities, checking pressure frequently during
inflation. The air spring requires much less air volume than
a tire and, therefore, inflates much quicker.
WARNING:
Do not inflate this assembly when it is unrestricted. The
assembly must be restricted by the suspension or other
adequate structure. Do not inflate beyond 100 psi Improper
use or over inflation may cause property damage or severe
personal injury.
AIR SPRING 6781 2
UPPER LEFT BRACKET 5474 1
UPPER RIGHT BRACKET 5475 1
LOWER BRACKETS 5476 2
BRACKET CLAMP 5433 2
3/8"-16 BAIL CLAMP 3373 2
3/8"-16 FLANGE NUT 12
3/8"-16 x 7" CARRIAGE BOLT 4
3/8"-16 X 3/4" FLANGE BOLT 2
3/8"-16 x 1" HEX BOLT 2
3/8"-16 NUT-ON-A-STICK 2
5/16"-18 J-BOLT 2
5/16"-18 HEX NUT 2
5/16" FLAT WASHER 4
AIR LINE TUBING 1
INFLATION VALVE 3032 2
ELBOW FITTING 3031 2
4" WIRE LOOM 2
THERMAL SLEEVE 2
NYLON TIE 6
CAUTION TAG 2
P
ARTS LIST