Rite-Ride 4146 - Manual (Page 3)

23-8506 06-08 NDD-4175-2
DESCRIPTION QTY.
HEAT SHIELD 1
CLAMPS 2
P
ARTS
L
IST
8506
www.riderite.com
EXHAUST PIPE
OPEN AIR
SPACE
OPEN AIR
SPACE
CLAMPS
E
XHAUST
C
LEARANCE
M
ODIFICATION
The exhaust clearance from the air spring should be
no less than 2 inches. If necessary, loosen the exhaust
clamps and rotate the the exhaust pipe to obtain addi-
tional clearance. Tighten the exhaust clamps after
rotation.
S
TEP
1
Bend the heat shield middle tab out at a 90 degree
angle and bend the heat shield again half the distance up
the tab at a 90 degee angle to form a "L" shape refer to
Figure "A".
S
TEP
2
Mount the heat shield between the air spring and the
exhaust pipe. Mount the heat shield using the clamps
provided see Figure "B". Maintain clearance between
heat shield and moving axle, lines, etc...
S
TEP
3
Bend the heat shield around the exhaust pipe, while
allowing for open air space of 1/2" to 1" as shown in
Figure "C".
BEND 1
90
°
BEND 2
90
°
BEND 1
90
°
BEND 2
90
°
Figure "A"
Figure "B" Figure "C"