Craftsman 65100 - Manual (Page 15)

15
ASSEMBLY
1. DO NOT assemble the Air Cleaner until you are
sure the tool IS NOT plugged in.
2. DO NOT assemble the Air Cleaner until you are
sure the power switch is in the “OFF” position.
3. For your own safety, DO NOT connect the machine
to the power source until the machine is completely
assembled and you read and understand the entire
Owner’s Manual.
The Air Cleaner can be used as a portable or stationary
unit. As a portable unit it can be moved and placed
near the work to be done. As a stationary unit it can be
hung overhead in the shop. Determine which type of
use is best fitted for your applications and proceed to
that section in the assembly instructions.
PORTABLE UNIT ASSEMBLY
MAKE CERTAIN THE AIR CLEANER IS DISCON-
NECTED FROM THE POWER SOURCE.
1. Place the Air Cleaner on its side. Locate the self-
adhesive rubber pads supplied with the unit.
Carefully place one rubber pad on each bottom
corner of the Air Cleaner. The rubber pads will help
eliminate vibration and noise.
CAUTION: For operator safety, we sugest that the
unit be clamped down when used on a workbench
or positioned on sawhorses.
2. There are two lifting handles located on each side
of the air cleaner. These handles should be used to
carry the Air Cleaner from place to place. To avoid
damage to the air filters, carry the air cleaner with
the filters positioned away from your body.
CAUTION: This Air Cleaner weighs approximately
55 pounds.
STATIONARY UNIT ASSEMBLY
THIS TOOL WEIGHS APPROXIMATELY 55 POUNDS.
MAKE CERTAIN THE UNIT IS SECURELY SUPPORT-
ED WHEN MOUNTING TO A CEILING OR OVER-
HEAD SUPPORT.
1. Remove four screws, one of which is shown at (A)
from top of Air Cleaner (B). See figure 2-1.
2. Thread a flange nut 5/16-18 approximately
half-way onto the eye-bolt 5/16-18 x 1-1/2” ).
3. Thread the eye-bolt with the flange nut assembled
into the hole where screw was removed in STEP 1.
NOTE: Thread each eye-bolt eight complete turns
into threaded hole.
4. Figure 2-2 shows one of the four eye-bolts (E)
assembled to the top of the Air Cleaner. NOTE: To
adjust the height of the Air Cleaner, loosen flange
nuts (F) and rotate eye-bolts as necessary. IMPOR-
TANT: For safety reasons, eye-bolts must be
threaded at least eight complete turns into tapped
hole in top of Air Cleaner. Make certain the flange
nuts are tightened down against the surface of the
Air Cleaner after height adjustments are made.
Fig. 2-2
Fig. 2-1
NEVER SECURE MOUNTING HARDWARE TO
DRYWALL, DROP CEILING TILE/FRAME OR NON-
STRUCTURAL MEMBERS.
KEEP A MINIMUM OF SEVEN FEET BETWEEN BOT-
TOM OF AIR CLEANER AND THE FLOOR.
DO NOT use rope, cable or power cord to suspend the
unit from the ceiling. We recommend that a chain
should be used and rated for a minimum of a 150
pound working load to firmly support the Air Cleaner.
IMPORTANT: When determining a location to mount
the unit, the Air Cleaner will operate more efficiently
when the air flow is unrestricted. Do not locate the unit
in a corner or near any heating or cooling vents.
B
A
E
F
WARNING !
WARNING !
WARNING !
WARNING !