SONIQ VBT50 - Manual (Page 6)

Care and Maintenance
9 10
Specification
Bluetooth Specification
Bluetooth Profile Supported
Frequency Range
Working Distance Range
Dimensions(main unit)
Weight (main unit)
DSP
Charging Time
Talking Time
Standby Time
Rechargeable Battery
Battery Protection
Input Current
Input Voltage
Speaker Power
Speaker Impedance
Sensitivity of Microphone
Version 2.0 compliant
Headset and Handsfree Profiles
2.4GHz spectrum
10 Meters (class 2)
115(L)×62(W)×21(T)mm
110g
Full duplex transmission, noise
suppression and echo cancellation.
Within3 hours
Up to 13 hours
Up to 200 hours
Lithoum-ion, 3.7V, 1000 mAh installoed
Over charge and over discharge protection
400mA <intemal controllrd>
DC 5V
2W<max>
4 ohm
-60dB±2dB
Check the laws and regulations on the use of mobile phones and handsfree
equipment in the area where you drive.
Always give full attention to driving. In some areas. You are required to pull
off the road and park before making or answering a call.
Do not expose it to handsfree to extreme temperature or direct sunlight
Do not expose it to moisture or humidity. Keep it away from any liquid or
Chemicals.
Do not keep the device in dusty area. Only use a soft damp cloth to clean it.
Do not attempt to disassemble the handsfree and the chargers.
Do not try to replace the rechargeable battery inside the handsfree.
Charge the handsfree only with the supplied charger.
Pairing with a phone
Before using the handsfree, you must pair it with the mobile phone first. Once the
handsfree and the phone has paired they store the ID of each other. Thus they
can connect each other automatically. You can check, delete or rename the
paired device in the devices list of the mobile phone.
1.Place the Bluetooth handsfree and the Bluetooth mobile phone within a
distance of 1 meter.
2.Switch on the Bluetooth mobile phone and enable Bluetooth feature. If the
phone has ‘profile ’ options, you are recommended to select ‘Handsfree Profile’
rather than ‘Headset Profile’ .
3.Press and hold the multifunction key for 6 seconds and the red and blue are
alternately flashing every second indicates in paired status.
4.On the Bluetooth mobile, searching for device, 'VBT50' will appear in the
device list.
5.Select device ‘VBT50’ and enter fixed pass key ‘0000’. Pairing completed .The
LED indicator turns blue steadily indicates the handsfree is connected to the
phone with Handsfree Profile.
6.Make sure the paired mobile has returned to main menu.
7.The volume is automatically set to middle level. For best performance, press
'+' or '-' to adjust a suitable volume level.
Check if the mobile displays any message or icon which indicates the connecting
status. After pairing completed, some phones automatically connect to
handsfree immediately.Some phones keep waiting for building up the connection
manually. In this case, press Multifunction key once, VBT50-AU will connect to
the phone. Or you can select ‘VBT50’ from the “Paired Device” of the phone. The
phone will connect to the handsfree. Please refer to your phone’s user manual.
You should now be able to make wireless communication with the handsfree.
Keep the distance between the handsfree and the mobile within 10 meters and
free from obstacles. You can dial and receive calls by the phone, or activate the
voice dialing to redial the last number and receive calls through the handsfree.
“Handsfree Profile” supports ‘Voice dial’, Redial the last number and Call
transfer functions. If the mobile phone only supports Headset Profile, those
functions are not available.