SoundOff Signal Raptor Surface Mount - Manual

To review our Limited Warranty Statement & Return Policy for this or any SoundOff Signal product please visit our website at www.soundoffsignal.com and select the “Warranty & Returns”
link along the left column of our home page. If you have questions regarding this product please contact Technical Services, Monday - Friday, 8 am to 5 pm at 1.800.338.7337, press #4 to
skip the automated message. Questions or comments that do not require immediate attention may be emailed to [email protected].
1.800.338.7337. / www.soundoffsignal.com / Thank you for trusting us with your safety!
OPERATION:
1) Connect RED wire 10-30Vdc and
BLACK wire to ground.
2) Connect PURPLE wire to 10-30Vdc
for Cruise light.
3) To change pattern momentarily touch
WHITE wire to ground.
!
WARNING
This product contains high intensity LED devices.
To prevent eye damage, DO NOT stare into the
light beam at close range.
Please see reverse for
Technical Specifi cations
• Warning devices are strictly regulated and governed by Federal, State and Municipal ordinances.
These devices shall be used ONLY on approved vehicles. It is the sole responsibility of the user of these
devices to ensure compliance.
• DO NOT install this product or route any wires in the Air Bag Deployment Zone. Refer to your vehicle
Owner’s Manual for the location of any air bag deployment zones.
• DO NOT connect this device to a strobe power supply. This product is self-contained and does not
require an external power supply.
ERPT1SSMDB(x) 9.09
Important Information:
INSTALLATION:
1) Determine a clean, fl at location on the
vehicle to mount the Raptor Single
Surface Mount Light.
2) Using the housing as a guide mark the
centers of the outside hole positions
and drill appropriate pilot holes. The
gasket may be used if care is taken
not to stretch it. Note: the holes will
be 105.3mm on center if properly
located.
3) Drill a n 1/2” (13mm) hole exactly
half way between the two pilot holes.
Note: this hole must be free of burrs
and sharp edges to prevent damage
to the wires.
4) Make electrical connections.
5) Place gasket over wires and install light
by screwing unit to mounting surface.
CAUTION: DO NOT OVERTIGHTEN.
WIRE HOOK-UP TABLE
WIRE COLOR: CONNECT TO:
RED +10-30Vdc
BLACK Ground (-)
WHITE ID/Pattern Select
PURPLE Cruise
RAPTOR SINGLE SURFACE
MOUNT LIGHT
ERPT1SSMDB(x)
PURPLE
WHITE
+10-30Vdc
RED
BLACK
5A