SoundOff Signal nFORCE Oval Grommet Housing User Manual
Installation, Nforce 6” oval recess mount grommet & housing
PNFSLSRVMTB 11.14
INSTALLATION:
1) Establish a position on the vehicle. Use the
cutout template (provided) on 2nd page and cut
hole. Insert grommet into cutout first and then
press the light assemble into the grommet.
nFORCE 6” Oval Recess Mount Grommet & Housing
PART NUMBER - PNFSLSRVMTB
IMPORTANT INFORMATION:
Warning devices are strictly regulated and governed by Federal, State and Municipal ordinances. These devices shall be used ONLY on approved vehicles. It is the sole responsibility of the user of these devices to ensure compliance.
To review our Limited Warranty Statement & Return Policy for this or any SoundOff Signal product, visit our website at
www.soundoffsignal.com/sales-support.
If you have questions regarding this product, contact
Technical Services, Monday - Friday, 8 a.m. to 5 p.m. Eastern Time or during extended after hours coverage between 5 p.m. & 8 p.m. Eastern
Time at
1.800338.7337 (press #4 to skip the automated message).
Questions or comments that do not require immediate attention may be emailed to
SUPERIOR CUSTOMER RELATIONSHIPS. SMARTLY DESIGNED LIGHTING & ELECTRONIC SOLUTIONS.
1.
GROMMET
nFORCE LIGHT
BEZEL
SUPPLIED SCREWS
x4
INSTALLATION INSTRUCTIONS
1. Insert nFORCE Light into supplied housing and
secure using the 4 supplied screws. Do not
exceed 12 IN-LBF
2. Place grommet in hole
3. Insert bezel/light assembly into grommet,
ensuring lip of bezel is fully engaged to groove
of grommet