SoundOff Signal GHOST Recess Mount ECE User Manual
Warning, Ghost® single recess mount light ece certified
1.800.338.7337 / www.soundoffsignal.com
IMPORTANT INFORMATION:
Warning devices are strictly regulated and governed by Federal, State and Municipal ordinances. These devices shall be used ONLY on approved vehicles. It is the sole responsibility of the user of these devices to ensure compliance.
To review our Limited Warranty Statement & Return Policy for this or any SoundOff Signal product, visit our website at
www.soundoffsignal.com/sales-support.
If you have questions regarding this product, contact
Technical Services, Monday - Friday, 8 a.m. to 5 p.m. at 1.800.338.7337 (press #4 to skip the automated message).
Questions or comments that do not require immediate attention may be emailed to
SUPERIOR CUSTOMER RELATIONSHIPS. SMARTLY DESIGNED LIGHTING & ELECTRONIC SOLUTIONS.
INSTALLATION:
1. Determine a clean, flat location on the
vehicle to mount the GHOST light.
2. Using template on reverse side, mark and
drill holes in 4 corners. Holes to be
Ø0.46”
(approx.
Ø15/32”).
3. Carefully cut sheet metal and ensure there
are no sharp edges.
4. Press gasket into opening.
5. Make electrical connections.
6. Test light.
7. Press light into gasket.
OPERATION:
WIRE CONNECTIONS
See setup procedure on second page.
The single GHOST comes equipped with
an internal flasher with 3 user selectable
patterns that can be synchronized either
alternating or simultaneous with up to three
other lights. It can also be put into slave
mode and driven through an external flasher.
1. Connect the GHOST BLACK wire to a
good, convenient ground.
2. Connect the GHOST RED wire to one side
of a user supplied on/off switch. Connect the
other side of the switch, through a 5Amp
fuse, to a source of +10-30Vdc.
3. Cruise mode is activated by applying
power to BROWN wire while RED wire is
powered. NOTE: Cruise mode is STEADY-ON
at 20% light output.
4. To sync lights and make pattern
selections see reverse side.
Please see reverse for
Technical Specifications
• Warning devices are strictly regulated and governed by Federal, State and Municipal ordinances.
These devices shall be used ONLY on approved vehicles. It is the sole responsibility of the user of these
devices to ensure compliance.
• DO NOT install this product or route any wires in the Air Bag Deployment Zone. Refer to your vehicle
Owner’s Manual for the location of any air bag deployment zones.
• DO NOT connect this device to a strobe power supply. This product is self-contained and does not
require an external power supply.
EGHSTE5(xx) 07.14
Important Information:
WIRE HOOK-UP TABLE
WIRE COLOR:
CONNECT TO:
RED
+10-30Vdc
BLACK
Ground (-)
WHITE ID/Pattern Select
BROWN WIRE
+10-30Vdc
!
WARNING
This product contains high intensity LED devices. To
prevent eye damage, DO NOT stare into the light
beam at close range.
GASKET
LIGHT ASSEMBLY
Note: Lens shown is
representative only.
GHOST® SINGLE RECESS MOUNT LIGHT
XYLEX LENS - ECE CERTIFIED
SINGLE LIGHT
EGHSTE5(x)B-EU - Black
EGHSTE5(x)W-EU - White
EGHSTE5(x)C-EU - Chrome
GHOST® SINGLE RECESS MOUNT LIGHT
ECE CERTIFIED
SINGLE LIGHT
EGHSTE5(x)B - Black
EGHSTE5(x)W - White
EGHSTE5(x)C - Chrome