SoundOff Signal UnderCover Strobe (Push-In) - Manual (Page 2)

Figure A.
ETUP0(x)-P 10/05
4. Install the amp 3 socket housing onto the end of the 3
conductor power cable to be connected to the Undercover
Remote Strobe Light Head Assembly, see Figure A. Connect
the cable and light first.
5. Install the amp 3 socket housing onto the end of the 3
conductor power cable to be connected to the Strobe Power
Supply, see Figure A. Connect this cable to one of the Strobe
Light outlets located on the Strobe Power Supply. Repeat the
installation instructions for the other remaining Strobe Light
Heads. Connect the Strobe Power Supply to the power source
as indicated in the instructions enclosed with the Power
Supply. Test the system.
NOTE
This testing may be performed before securing
the remote Strobe Light Head Assembly to
the mounting surface of the "Composite"
housing assembly as described in Section 2.
WARNING
OBSERVE THE COLOR OF THE WIRES TO
BE CONNECTED TO PIN NUMBER
POSITIONS when connecting the amp
connector housings to the amp pins and
sockets, see Figure A.
IMPORTANT CABLE INFORMATION
The cable supplied with the Undercover Strobe Head is a
shielded type with a length of shield wire exposed on each end.
On the end of the cable at the Undercover Strobe Head, cut the
shield flush with the cable jacket. On the other end of the cable,
by the Power Supply, the shield wire is to be grounded to the
vehicle chassis to reduce radio or other communication sys-
tem interference. ALWAYS KEEP THIS WIRE AS SHORT AS
POSSIBLE WHEN GROUNDING. If this ground shield wire is
not to be installed, cut it flush with the cable jacket.
NOTE
SoundOff Signal Strobe Light Systems are
designed to interface with SoundOff Signal
Strobe Light Power Supplies. They are also
100% field compatible with Whelen and Tomar
Power Supplies, cables and light heads.
Detailed wiring, switching and installation
instructions are enclosed with the Strobe
Light Power Supply.
WARNING
The Strobe Power Supply is a high voltage
device, therefore DO NOT remove Strobe
Tubes or dismantle light heads while unit is
operating. ALWAYS WAIT TEN MINUTES
AFTER TUNING OFF THE POWER BEFORE
STARTING ANY TROUBLE SHOOTING.
AMP 3 PIN CONNECTOR HOUSING
(to be mated with the AMP 3 Position
Socket on the Power Supply)
Insert wires with Pins into the
proper locations in the Housing:
RED WIRE - HOLE #1
BLACK WIRE - HOLE #2
WHITE WIRE - HOLE #3
RED WIRE - HOLE #1
BLACK WIRE - HOLE #2
WHITE WIRE - HOLE #3
Insert wires with Sockets
into the proper locations in
the housing:
AMP 3 SOCKET
CONNECTOR HOUSING
WIRE HARNESS w/ AMP
3 PIN CONNECTOR
(attached to Undercover
Strobe Light Head)
1
2
3
1
2
3
12
3
Ridge on AMP Connectors
indicate the location of Hole #1
To crimp Pins on wires,
strip insulation approx. 1/8"
to expose bare wire
Crimp short Cradle
over bare wire
Crimp tall Cradle
over wire insulation
1
2
3
To Reduce EMI emissions, ONE end of the shield (drain wire)
of the extension cable connecting the output of the power
supply to the Lighthead should be connected to ground. Make
sure ONLY ONE END of the shield is tied to ground. The
other end needs to be taped or cut.
WARNING
PERSONAL INJURY HAZARD
Mounting this device in an improper location may
impair the designed safety characteristics of
the vehicle in the event of a collision.
Consult the vehicle manufacturer before
installing this or any other aftermarket device to
determine its proper mounting location.
Failure to consult and follow the vehicle
manufacturer’s mounting recommendations
may result in serious personal injury or death.
!