SoundOff Signal 400 Series Remote Siren User Manual
Warning
ETSA48(x)RSP-CVR 3.4.2013
IMPORTANT INFORMATION:
Warning devices are strictly regulated and governed by Federal, State and Municipal ordinances. These devices shall be used ONLY on approved vehicles. It is the sole responsibility of the user of these devices to ensure compliance.
To review our Limited Warranty Statement & Return Policy for this or any SoundOff Signal product, visit our website at
www.soundoffsignal.com/sales-support.
If you have questions regarding this product, contact
Technical Services, Monday - Friday, 8 a.m. to 5 p.m. at 1.800338.7337 (press #4 to skip the automated message).
Questions or comments that do not require immediate attention may be emailed to
SUPERIOR CUSTOMER RELATIONSHIPS. SMARTLY DESIGNED LIGHTING & ELECTRONIC SOLUTIONS.
400 SERIES REMOTE SIREN
W/ 380R REMOTE CONTROL PANEL
ETSA481RSP - 100W
ETSA482RSP - 200W
Please see page 3 for
Technical Specifications
!
WARNING
Sirens produce loud sounds that
may damage hearing:
- Roll up windows.
- Wear hearing protection.
- Use only for emergency response.
- Avoid exposure to siren sound
outside of vehicle.
Remote Control Panel (Universal Bail
Amplifier
Microphone
Introduction
The ETSA48(x)RSP is Remote Mounted
Siren Amplifier controlled by a dashboard
located control panel. The 100W version
(481) can power a single speaker while the
200W unit (482) contains dual amplifiers
and can power two independent speakers.
The ETSA48(x)RSP can also drive a variety
of programmable powered control lines
capable of up to nine 10A and three 20A
circuits.
Notice
Sirens provide an essential function of an
effective audio / visual warning system.
However, sirens are only short range
secondary devices. The use of a siren does
not insure that all drivers can or will abide
by or react to an emergency warning signal,
especially at high rates of speeds or long
distances. The operator of the vehicle must
never take the right of way for granted and
it is the operator’s responsibility to proceed
safely.
The effectiveness of this siren system is
highly dependant on the correct mounting
and wiring. The installer must read and
follow the manufacturer’s installation
instructions and warnings in the manual.
The vehicle operator should verify the siren
system is securely fastened to the vehicle
and properly functioning.
Effective sirens generate loud sound
pressure levels that can potentially cause
hearing damage. Installers and those around
the vehicle need to be aware of the dangers
and wear hearing protection whenever the
siren system is operating. Vehicle operators
and occupants should assess their exposure
to siren noise and determine what steps
need to be taken to prevent hearing damage.
The siren system is intended for use by
authorized personnel only. It is the user’s
responsibility to ensure they understand and
operate the emergency warning devices in
compliance with all applicable city, state,
and federal laws and regulations. SoundOff
Signal assumes no liability for any loss
resulting from the use of the siren system.
IMPORTANT NOTICE TO INSTALLER:
Make sure to read and understand all
instructions and warnings before proceeding
with the installation of this product. Ensure
the manual and all warning cards are
delivered to the end user of this equipment.
PSRN4ANRI - 100W
PSRN4ANR2 - 200W
PSRNCTRL1
Package Contents:
1 ea. Amplifier Box
1 ea. Microphone Bracket w/ Mounting
Hardware
5 ea. Amplifier Wire Harnesses with
Connectors (1-4 pin, 1-12 pin, 1-5
pin 1-14 pin and 1-8 pin)
2 ea. Instruction Manual
1 ea. Operators Warning Card to remain
in vehicle for operator review
1 ea. Sound Pressure Warning Label that
is to be attached in vehicle and in
plain site of operator and occupants
of the vehicle
1 ea. Mounting Bracket with Hardware
1 ea. Label Card for Aux. Switches
1 ea. Remote control panel
1
1.800.338.7337 / www.soundoffsignal.com