Stealth Cam STC-AD3 I390 - Manual (Page 29)

STC-AD3
www.stealthcam.net Toll Free 877-269-8490 29
Testing the camera coverage area
One of STC-AD3 Cam’s many features is the ability to test the
coverage area.
• After mounting the camera, open front housing and slide the
power toggle switch to TEST.
• Close the front housing.
• Walk around in the front of the camera to see if you have
mounted camera in the proper position. A green indicator light
on the front will blink on when you have intruded the coverage
area.
• Adjust the camera position as needed and repeat testing until
the desired coverage area is achieved.
• When you have completed the testing the coverage area, open
the front housing and slide the power toggle switch from TEST
to ON position. This will exit the test mode. The camera will
then enter count down mode for 1 minute and front green
indicator will start continuous blinking giving you one minute to
leave the coverage area. Then the camera will enter PIR
detection mode.