Stealth Cam STC-WD2X V230 - Manual (Page 25)

STC-WD2X
www.stealthcam.net Toll Free 877-269-8490 25
• Walk around in the front of the camera to see if you have
mounted camera in the proper position. A green indicator light
on the front will blink on when you have intruded the coverage
area.
• Adjust the camera position as needed and repeat testing until
the desired coverage area is achieved.
• When you have completed the testing the coverage area there
are 2 methods for exiting the test mode:
a. Open the front housing and press the [TEST] button to exit
test mode. The camera will then enter count down mode
for 1 minute and front green indicator will start blinking
giving you one minute to leave the coverage area. Then
the camera will enter PIR detection mode.
b. After 5 minutes in test mode, the camera will then enter
count down mode for 1 minutes and the front green
indicator will start blinking giving you one minute to leave
the coverage area. The camera will enter PIR detection
mode.