CDA DUAL FUEL COOKERS RC 9021 - Manual (Page 29)

29
FOR THE INSTALLER
Location
The appliance may be installed in a kitchen, Kitchen/diner or a bed sitting room, but not in a room or
space containing a bath or a shower.
The appliance must not be installed in a bed-sitting room of less than 20m
3 .
The appliance is designed and approved for domestic use only and should not be installed in a commercial,
semi commercial or communal environment.
Your product will not be guaranteed if installed in any of the above environments and could affect any
third party or public liability insurances you may have.
This cooker has class “2/1” overheating protection so that it can be installed next to a
cabinet.
– If the cooker is installed adjacent to furniture which is higher than the gas hob cooktop, a gap of at least
200mm must be left between the side of the cooker and the furniture.
– The furniture walls adjacent to the cooker must be made of material resistant to heat.
– The veneered synthetic material and the glue used must be resistant to a temperature of 90°C in order
to avoid ungluing or deformations.
– Curtains must not be fitted immediately behind appliance or within 500mm of the sides.
– It is essential that the cooker is positioned as stated below.
– If the cooker is located on a pedestal it is necessary to provide safety measures to prevent falling out.
– The cooker must be installed by a qualified technician and in compliance with local safety
standards.
650 mm
200 mm
500 mm
450 mm
Fig. 30