Forum, Owner’s manual – TeachLogic Forum User Manual
Page 18
owner’s manual
12
Forum
note
system operation
•
On Forum set Ch A & B volume controls to off
(counter clock wise)
•
Turn the Forum “ON”, Blue LED will light
•
Confirm power to ceiling sensor, Green LED on
edge of sensor will light
•
Using a Sapphire Transmitter microphone.
(Sapphire Mics are shipped in channel A)
•
Sapphire: “A–B” switch, remove battery cover
on back, under battery.
•
Handheld: Unscrew barrel and remove.
Note “A–B” switch on side of battery holder.
•
Turn sensitivity control on Sapphire transmitter
to "HI" level position
•
Switch transmitter “on” by depressing and hold
front button until (Blue) LED is present
•
Observe signal presence LED (Orange) on
Forum receiver adjacent to “Mic” volume control
•
Stand under or in front of a speaker
•
Slowly adjust “Ch A” volume on Forum while
talking into microphone
•
Adjust to desired listening level.
CAUTION: Beware of feedback
•
Walk around the room while talking into
microphone to confirm good connectivity
Upon completion of performance test,
the installation is complete.
Now that the system is installed and connected, we are ready to turn the system “ON” and test
its performance. The testing will be done using an IR transmitter (Sapphire or Handheld) to
confirm good connectivity and quality audio.
operation of wireless microphone