TeachLogic Maxim III - Manual (Page 23)

troubleshooting
System is turned
“on” but there is no
sound
System has power
but no sound
Voice is distorted
and/or signal drop-
out occurs
• Verify AC power; the Red
LED lights when turned
“on”
•
Check if system has
been unplugged
•
Check circuit breaker
•
Call maintenance for
assistance
• Turn “on” microphone/
transmitter
• Check for IR transmission,
Signal presence (Orange
LED)
• Check the Yellow LED in
the sensor
• If sensor LED is not lit
•
Sensor has been
disconnected
•
Power output to sensor
has failed (Receiver/
amplifier needs to be
replaced)
• Check the charge on your
batteries
• Verify power switch in
battery compartment is in
“Hi” position (Body-Pack
transmitter)
• Verify that the diodes on
transmitter or sensor are
not being covered
• Obstruction between
transmitter and sensor
17
Problem Solution
contact
If your problem persists
and this guide has not
resolved the issue, call our
customer service depart-
ment for additional assis-
tance. (800) 588-0018