TeachLogic VOICELINK I - Manual (Page 15)

9
system operation
•
Turn the VoiceLink III “ON”, Blue LED will light
•
Confirm power to sensor, Green LED on edge of
sensor
•
Set volume of Ch A volume control to mid scale
(12 o’clock)
•
Using a Sapphire Transmitter microphone select
channel “A” (Mics are shipped in channel A)
•
Sapphire: “A–B” switch, remove battery cover
on back, under battery.
•
Handheld: Unscrew barrel and remove.
Note “A–B” switch on side of battery holder.
•
Turn volume control on Sapphire transmitter to
mid level between "HI" and "LOW"
•
Switch transmitter “on”
•
Observe power LED (Blue) - use fully charged
battery only
•
Observe signal presence LED (Orange) on
receiver adjacent to “Mic” volume control
•
Stand under or in front of a speaker
•
Slowly adjust “Ch A” volume on VoiceLink III
while talking into microphone
•
Adjust to desired listening level.
CAUTION: Beware of feedback
•
Walk around the room while talking into
microphone to confirm good connectivity
Upon completion of performance test,
the installation is complete.
operation of VoiceLink III system
Now that the system is installed and connected, we are ready to turn the system “ON” and test
its performance. The testing will be done using an IR transmitter (Sapphire or Handheld) to
confirm good connectivity and quality audio.