Canon Elura 70 - Manual (Page 61)

61
Advanced Functions - Recording
E
Using Headphones during Recording
The headphones terminal also serves as AV terminal. Headphones can only be used
when "
H" is displayed on the screen. If not, change the setting following the
procedure below.
Open the menu and select [VCR SETUP]. Select [AV/PHONES
H ], set it to
[PHONES
H ] and close the menu.
Adjusting the Headphone Volume
Open the menu and select [AUDIO SETUP]. Select [
H VOLUME], adjust the
volume with the SET dial and close the menu.
You can turn off the volume completely by turning the SET dial down until [OFF] appears.
Turn the SET dial up to increase the volume again.
Recording with an External Microphone
You can attach a commercially available
microphone or the optional DM-50 Directional
Stereo Microphone to the accessory shoe.
Refer also to the instruction manual of the
microphone.
1. Attach the microphone to the
accessory shoe.
2. When using a commercially available
microphone, connect it to the MIC
terminal.
❍ When recording in silent places, the built-in microphone may pick up the
motor noise of the camcorder. In such case, we recommend using an external
microphone.
❍ When using a commercially available microphone:
- Use a microphone with built-in power supply (condenser microphone). Almost
all stereo microphones with a plug diameter of 0.14 in. (3.5 mm) can be
connected. The audio level may differ from that of the built-in microphone.
- Long microphones may appear on the screen.
CARD PLAY CARD CAMERA PLAY (VCR) CAMERA
CARD PLAY CARD CAMERA PLAY (VCR) CAMERA
VCR SETUP AV/PHONES ••AV
( 38)
HVOLUME••••• AUDIO SETUP
( 38)