tekmar 406 House Control User Manuals - Manual

tekmarNet ® 2 House Control 406
U 406
12/11
Alternative
Energy
Replaces: New
User Brochure
1 of 4 © 2011 U 406 - 12/11
This brochure includes details about how to view and adjust settings within the tekmarNet ® House
Control 406. Advanced operational information is available in the Installation and Operation
Manual D406. Please visit www.tekmarcontrols.com for more detailed information on this or
any other tekmar product.
This control operates a heat pump and backup boiler to provide hot or chilled water to a storage
tank. Floor cooling is available with or without a humidity sensor. A backup boiler is able to
provide heat for domestic hot water, setpoints, or as a backup to the storage tank.
Calls
CALLS
Displays any call for heat or cool the control
is receiving.
Pumps
PUMPS
Displays any pump currently operating.
Zones
1 2 3 4
ZONES
Displays if an on-board zone is operating.
Var
VARIABLE SPEED PUMP OUTPUT
Displays percent output of the variable
speed pump.
WWSD / CWSD
The system is currently in Warm Weather
Shut Down or Cold Weather Shut Down.
MIN / MAX
Heat pump is prevented from operating due
to high or low return water temperature.
OCCUPIED
Indicates that a User Switch or Timer has
put the system into Occupied.
UNOCCUPIED
Indicates that a User Switch or Timer has
put the system into UnOccupied.
HEAT PUMP
Heat pump stage 1 or 2 is operating.
Aux
AUXILIARY
An auxiliary backup heat source is currently
operating using the Backup relay.
BOILER
Indicates that the boiler is operating (flashing
flame indicates boiler is igniting).
FLOOR
Radiant floor cooling is currently active.
BACKUP
Backup heat source is required to assist in
heating the tank sensor to its target.
COOL / HEAT
The heat pump is operating in either cool
or heat mode.
°F°C minhr
sec%
°F, °C, MINUTES, HOURS, SECONDS, %
Units of measurement for current number.
WARNING
Displays if an error exists on the system.
Aux
Setpoint Xfr
Var
Number Field
Displays the
current value of
the selected item
Status Fields
Displays the current status
of the control’s inputs,
outputs and operation. Most
symbols in the status field
are only visible when the
VIEW Menu is selected
Menu Field
Displays the
current menu
Symbols
Display
Item Field
Displays the name
of the selected item