tekmar 007 Adaptor Plate - Manual

1 of 4 © 2007 D 007 - 05/07
- Data Brochure
Adaptor Plate 007
D 007
05/07
Installation - Adaptor Plate 007
The Adaptor Plate 007 allows for installation of a small enclosure Room Temperature Unit
(RTU) or Indoor Sensor or Thermostat on to a 2” x 4” electrical box. The adapter plate can
be mounted vertical or horizontal and is designed to allow wiring to feed through in any
position. Included with the adaptor plate are surface painted screws for mounting to the 2” x
4” electrical box and screws to mount the RTU / Indoor Sensor to the plate.
STEP ONE
GETTING READY
Check the contents of this package. If any of the contents listed are missing or damaged,
please contact your wholesaler or tekmar sales representative for assistance.
Type 007 includes: • One Adaptor Plate 007 • Two electrical cover screws • Two 5/16”
screws • One Data Brochure D 007
STEP TWO
MOUNTING THE PLATE
The Adaptor Plate is mounted onto a standard 2” x 4” electrical box using the supplied
screws. Ensure the electrical box is properly insulated and protected from cold drafts. All
required RTU or Indoor sensor wiring must be pulled through the existing top left hand hole
of the adaptor plate. The adaptor plate may be mounted horizontally or vertically using the
electrical cover screws provided.
STEP THREE
MOUNTING THE SENSOR / RTU ————————
Insert the wiring through the hole provided in the back of the sensor or RTU enclosure,
and connect them to the wiring terminals as described in the applicable Sensor / RTU
Data Brochure. Attach the sensor or RTU to the adaptor plate using the supplied 5/16”
screws.
Do not over tighten screws as the plastic molding may strip.