Teradek Bolt Pro 2000 - Manual

NEED MORE HELP?
1. Support forum: http://support.teradek.com → Contains tips, information and all the latest firmware & software updates.
2. Training videos: http://www.teradek.com/trainin
g
TERADEK SUPPORT STAFF: support @teradek.com or call 888−941−2111 ext2 (Mon−Fri 7am to 6pm PST)
Bolt Pro 2000 Receiver
A: RP -SMA Connector
B: Power Status
C: Video Status
D: Link Status
E: Fault LED
F: Power Switch
G: 7 -17V DC Input
H: Battery Mount
I: 3G -SDI Outputs
J: RX Antennas
B
C
D
E
G
A
G
A
F
J
I
H
Bolt Pro 2000 Transmitter
CONNECT AND POWER YOUR DEVICE
Connect the SDI output from your video source to the HD/3G -SDI input (J) on the
Bolt transmitter. Connect either of the HD/3G -SDI outputs from the Bolt receiver
to the SDI input on your monitor.
Uncompressed Long-Range
Wireless HD Video
The Bolt Pro 2000 is a zero delay wireless
video transmission system designed for
the most demanding cinema, broadcast,
and UAV applications. At less than 1ms
latency, Bolt Pro 2000 can transmit
1080p60 4:2:2 video at up to 2000ft line
of sight over the unlicensed 5GHz band.
Attach the two larger TX antennas (K) to the transmitter and the five smaller RX
antennas (J) to the receiver via the threaded RP -SMA connectors (A) .
Move the power switches on both the transmitter (G) and receiver (F) to the ON position.
Video appears within a few seconds.
Connect power to your Bolt transmitter using the included P -Tap to Lemo cable.
Power the Bolt receiver with the included A/C adapter or battery plate
accessory. If using the battery plate, connect a compatible battery (AB Gold mount
or V
-Lock) to the plate, and connect the short cable from the plate to the receiver’s
DC input (G) .
1
3
4
2
AC adapter
P -Tap to Lemo
Cinecoil SDI
A
A
I
F
J
K
H B
C
D
E
A: RP -SMA Connector
B: Video Status
C: Link Status
D: Power Status
E: Fault LED
F: USB Port
G: Power Switch
H: 6 -28V DC Input
I: 3G -SDI Output
J: 3G -SDI Input
K: TX Antennas