Trail Master Suspension TM409E 2005– 2012 FORD F-250/F-350 4WD 2 1/2 SPACER KIT - Manual (Page 4)

TM409E
Revised
8.9.13
4
Install Front
Suspension
1. Measure and record the distance from
the center of each wheel to the top of
its fender opening. Record below.
2. Place the vehicle in neutral. Place
your floor jack under the front axle
and raise the vehicle. Place jack
stands under the frame rails and lower
the frame onto the stands. Remove the
jack and place the vehicle back in
gear, set the emergency brake, and
place blocks both in front and behind
the rear wheels.
3. Remove the front wheels.
4. Raise the axle using the floor jacks to
remove the tension from the shocks.
5. Disconnect the end links to the sway
bar, frame brake line bracket and OE
shocks. (both sides).
6. Lower the front axle as far as possible.
Remove only one spring (mark or note
spring orientation before removal).
Remove OE spring isolator.
7. Compress spring down, install new
coil spacer (94-2859), poly ring (90-
4198), OE spring isolator and reinstall
spring. Be sure to line up the previ-
ously applied coil spring reference
Coil
Spring
90-4198
Poly Ring 94-2859
Coil Spacer
Lower
Shock
Mount
Brake
Line
Bracket