Trail Master Suspension TM3440-20013 JEEP WRANGLER (TJ) 4 SPRING KIT - Manual (Page 5)

5
3. Repeat steps 1 and 2 on the remaining side of
the vehicle.
4. Carefully lower the front axle to ease in the new
coil spring installation. Using the factory isola-
tors install the coil springs (TM3440-60010) into
the spring buckets
5. Raise the front axle into place. Make sure the
coil spring seats properly on the lower spring
perch.
6. Install your new front shocks (TM73245011) and
install the lower shock mount to the axle mount
using the previously removed OE hardware.
7. Assemble the front sway bar end links (82-
TM30014) by install bushings (45359) in the
top and bottom of the sway bar end links. In-
stall the 5/8” sleeve (61150) into the top sway
bar end link bushings only.
8. Install the sway bar adapter bracket (35-
TM20015) onto the sway bar using the 3/8” X 1
1/2” bolt, spacer (35-TM30018) and hardware.
9. Install sway bar end links (82-TM30014) into the
adapter (35-TM20015) using the 3/8” X 2 1/2”
bolt and hardware. The jog in the sway bar will
face towards the outside of the vehicle.
10. Secure the sway bar end link lower mount to the
axle mount using the previously removed OE
bolts and hardware.
11. Reinstall the brake line drops to the frame using
the previously removed OE hardware.
12. Install shifter drop bracket (35-TM20014) to
pivot bracket using 6mm hardware provided.
Install assembly into the existing mounting loca-
tion using hardware previously removed.
TM3440-60010
Coil Spring
TM73245011
Front Shock
35-TM20015
Adapter
Bracket
82-TM30014
Sway Bar End
Link
3/8” x
2 1/2”
Bolt
3/8” x
1 1/2”
Bolt
Axle
Mount
Sway Bar
OE
Bolt
35-TM30018
Spacer