Trail Master Suspension TM403N FORD F-150 4WD SUSPENSION LIFT KIT - Manual (Page 14)

TM403N
Revised
12.5.13
14
Illustration 14. Rotate the driveshaft to
check for binding. If it binds the drive-
shaft must be clearanced by a qualified
driveline shop.
NOTE: The use of this driveshaft
spacer is intended for light usage
only. If the intended usage is for high
speed off road, this spacer should not
be installed. The factory rear drive-
shaft should be lengthened by a quali-
fied driveline shop.
IMPORTANT!: Fully cycle the
rear suspension and check for drive-
shaft plunge. If the driveshaft is too
long it will destroy the transfer case.
Trail Master takes NO responsibility
for damage caused as a result of the
installation of this kit.
13. Reinstall the wheels and tires and
lower the vehicle to the ground.
14. Reinstall the wheels and tires and
lower the vehicle to the ground. Torque
the factory wheels to
150 ft/lbs. If you
are using aftermarket wheels follow the
manufacturers recommended specifica-
tions.
15. Recheck all hardware for proper in-
stallation and torque at this time.
Illustration 14
Rear Driveshaft Spacer
Rear
Driveshaft
Driveshaft
Spacer 90-4338
Rear
Differential
(4) 12mm X
60mm Bolts
and Washers