Trail Master Suspension TM3330-40053 JEEP WRANGLER 4 DOOR (JK) 3 SPRING KIT - Manual (Page 7)

7
3. Torque the 14mm track bar drop hardware ac-
cording to the torque chart on page 9 and the
OE bolt to 125 ft./lbs.
4. Carefully lower the front axle to ease in the new
coil spring installation. Using the factory isola-
tors install the coil springs (
TM3330-60040 ) into
the spring buckets
5. Raise the rear differential and make sure that
the coil springs are in their saddles.
6. Install the rear bump stop extensions (82-
TM20012) to the rear axle bump stop pad using
the supplied 8mm X 20mm bolts and hardware.
7. Reinstall the rear track bar to the axle mount us-
ing the previously removed OE hardware.
8. Install the rear track bar to the track bar drop
bracket using the supplied 14mm X 75mm bolt
and hardware. Torque to
100 ft./lbs.
9. Reconnect the lower sway bar links to the axle
using the previously removed OE hardware.
82-TM20012 Rear
Bump Stop Exten-
8mm X
20mm Bolts
82-TM20011
Track Bar
Drop Bracket
35-TM30010
Sleeve
TM3330-
60040 Rear
Coil Spring
OE Track
Bar Bolt
12mm X
30mm Bolt
OE Track
Bar
14mm X
75mm Bolt
82-TM20011
Track Bar Drop
Bracket