Tweco CutMaster 10mm - Manual (Page 30)

cutmaster 10mm
OPERATION 4-4 Manual 0-5074
D. Gas Selection
Ensure gas source meets requirements (refer to Section 2). Check connections and turn gas supply on.
E. Connect Work Cable
Clamp the work cable to the workpiece or cutting table. The area must be free from oil, paint and rust. Connect
only to the main part of the workpiece; do not connect to the part to be cut off.
Art # A-03387
F. Power On
Place the Power Supply ON / OFF switch to the ON (up) position. AC indicator turns on.
A-07932
A
30 20
26
28
24
22