Tweco 35A CutSkill Power Supply and SL40 Torch EU version - Manual (Page 24)

cutskill 35A
OPERATION 4-4 Manual 0-5180
G. Set Operating Pressure
Place the power supply RUN / SET switch to the SET (down) position. Gas will flow. Adjust gas pressure to 65
psi / 4.5 bar. Air indicator turns on.
NOTE
If gas regulator leaks, reset gas pressure to 0 psi, then reset to 65 psi / 4.5 bar.
Gas Pressure Regulator/
Filter Assembly
Gas Pressure Gauge
Art # A-09176
H. Select Current Output Level
Place RUN / SET switch to RUN (up) position. Gas flow will stop. Set the desired current output level.
Art # A-09181
RUN
SET
CURRENT (A)
15
25
35
READY AIR OVERHEAT POWER