Caravell slimline english, 6 maintenance, 7 troubleshooting – Caravell Slimline SLC 168 User Manual

Page 7: 8 disposal, 9 special considerations, 10 guarantee

Advertising
background image

Caravell Slimline

ENGLISH

7

Keep the cover open or remove the sliding covers and place
them carefully on the floor.

Remove the ice layer using plastic or wooden implements
(never use metal implements).

The de-icing process can also be speeded up by using bowls
of hot water.

Never use pointed or sharp implements.

After de-icing, clean the cabinet as described under Section

6. Dry thoroughly after cleaning.

6 Maintenance

Please note the following in connection with cleaning of the

freezer:

Place the products from the freezer in a cold place or wrap
them in insulating material.

The cabinet should be switched off at the socket.

Keep the cover open or remove the sliding covers and place

them carefully on the floor.

The freezer can be cleaned with luke warm water and mild

detergent. It should then be washed with clean water.
Never use detergents which contain chlorine.
Never use pointed or sharp implements.
Clean the cover in the same way as the cabinet. If the freezer is
fitted with a condenser and associated fan at the bottom rear of

cabinet, dirt and dust can collect on the cooling element. If
cleaning is necessary, the power should be switched off, the cover

removed and the cooling element vacuum-cleaned with a soft

brush.
Remove the cover as follows. Remove all screws holding the

cover in place and put to one side. Carefully draw the cover out as

far as possible (taking care not to damage the thermostat’s sensor
cable). It will now be possible to access the cooling element with

the vacuum cleaner brush.
Be aware that the cooling element consists of sharp

components and may be hot to touch.
After cleaning, refit the cover and insert and tighten all screws.

7 Troubleshooting

If you experience any problems with your freezer, please check

the following before seeking assistance:

Is the plug inserted?

Is the socket switched on?

Is the fuse in the meter cabinet intact?

Has any fault current relay been disconnected?

Has there been a complete power failure?

If the cabinet is very hot or air circulation is poor, you should

provide the necessary circulation.
If the condenser is dirty, it should be vacuum-cleaned.
If you have checked the above and the freezer is still not working,

call a service engineer.
State the type of fault and appliance, serial number and item no.

(shown on the manufacturer’s plate on the back of the cabinet).

8 Disposal

The owner of the freezer is responsible for disposing of the freezer

in a responsible way in accordance with the relevant legislation.
When a life-expired freezer is to be disposed of, it should be

disposed of in an environmentally friendly and responsible

manner.
Be aware of the rules for disposal. There may be special

regulations which must be followed.
You can obtain information on disposal from:

Your dealer

The relevant authorities (municipal authority, environmental

protection agency or other similar body)

WEEE marking.

Handling of life-expired electrical and electronic products. (Applies
to the European Union and other European countries with

separate collection systems.)

9 Special considerations

The information in this user manual was correct at the time of

printing.
Due to our programme of continuous product development, we
must however reserve the right to make technical changes to the

freezer models concerned. We will of course strive to continually

update the user manual.
You should contact your dealer if you are in any doubt concerning
the correct use of the freezer. They will be able to advise you on

this.
The manufacturer accepts no liability for accidents or
complications caused by the incorrect connection of the

equipment.

10 Guarantee

Any guarantee will be void if the product has been misused!
This means used for purposes other than that originally intended,

failure to follow the instructions in this manual and transport of the

product not in its original packaging.
If changes are made to the freezer by unauthorised personnel, the

manufacturer accepts no liability in connection with material

damage and/or personal injury.

Advertising
This manual is related to the following products: