Tweco 200 XT Auto-Cut 380V - Manual (Page 3)

!
WARNINGS
Read and understand this entire Manual and your employer's safety practices before installing,
operating, or servicing the equipment.
While the information contained in this Manual represents the Manufacturer's best judgement,
the Manufacturer assumes no liability for its use.
Plasma Cutting Power Supply, Auto-Cut ® 200 XT™
Operating Manual No. 0-5253
Published by:
Victor Technologies
82 Benning Street
West Lebanon, New Hampshire, USA 03784
(603) 298-5711
www.thermal-dynamics.com
© Copyright 2013 by
Victor Technologies
All rights reserved.
Reproduction of this work, in whole or in part, without written permission
of the publisher is prohibited.
The publisher does not assume and hereby disclaims any liability to any
party for any loss or damage caused by any error or omission in this Manual,
whether such error results from negligence, accident, or any other cause.
Publication Date: January 3, 2013
Revision Date: January 16, 2014
Record the following information for Warranty purposes:
Where Purchased: ___________________________________
Purchase Date:______________________________________
Power Supply Serial #:_______________________________
Torch Serial #:_______________________________________