Fabricator 211i installation/setup – Tweco 211i Thermal Arc Fabricator User Manual

Page 56

Advertising
background image

FABRICATOR 211i

INSTALLATION/SETUP

INSTALLATION/SETUP

3-24

Manual 0-5157

E. Switch the LOCAL/REMOTE switch inside the

wire feed compartment to LOCAL to use the

Power Sources Wirespeed and Voltage controls.

F. Switch the MIG GUN/SPOOL GUN switch inside

the wire feed compartment to MIG GUN.

WARNING

Before connecting the work clamp to the work make sure the Electricity Supply is switched OFF.

CAUTION

Loose welding terminal connections can cause overheating and result in the male plug being fused in the

terminal.
Remove any packaging material prior to use. Do not block the air vents at the front or rear of the Welding

Power Source.

Work Lead

Positive Welding

Terminal (+)

Negative Welding

Terminal (-)

MIG Polarity Lead

Art # A-11245

MIG Gun

8 pin plug

Figure 3-20: Setup for MIG Welding with Gasless MIG Wire

Advertising