Tweco Ultima 150 User Manual
Plasma welding power supply
Advertising
Table of contents
Document Outline
- SECTION 1: INTRODUCTION
- 1.01 Notes, Cautions and Warnings
- 1.02 Important Safety Precautions
- 1.03 Publications
- 1.04 Note, Attention et Avertissement
- 1.05 Precautions De Securite Importantes
- 1.06 Documents De Reference
- 1.07 Declaration of Conformity
- 1.08 Statement of Warranty
- SECTION 2: GENERAL INFORMATION
- 2.01 Scope of this Manual
- 2.02 ULTIMA-150 Power Supply Description
- 2.03 ULTIMA-150 Power Supply Specifications
- 2.04 The ULTIMA-150 System
- 2.05 Requirements to Complete System
- 2.06 Options, Accessories, and Replacement Parts
- 2.07 Introduction to Plasma Arc Welding
- 2.08 Theory of Operation
- SECTION 3: INSTALLATION
- 3.01 Introduction
- 3.02 Site Location
- 3.03 Unpacking
- 3.04 Primary Input Power Connections
- 3.05 Voltage Changeover
- 3.06 Work Cable Connection
- 3.07 Plasma and Shield Gas Connections
- 3.08 Torch Connection
- 3.09 Remote Connections
- 3.10 Filling Coolant Reservoir
- SECTION 4: OPERATION
- 4.01 Introduction
- 4.02 Operating Controls and Indicators
- 4.03 Basic Operation
- 4.04 Torch Operation
- SECTION 5: GENERAL MAINTENANCE
- 5.01 Introduction
- 5.02 General Maintenance
- 5.03 Basic Troubleshooting
- 5.04 Basic Parts Replacement
- SECTION 6: PARTS REPLACEMENT
- 6.01 Introduction
- 6.02 Returns
- 6.03 Ordering Information
- 6.04 Complete Systems
- 6.05 Power Supply Only
- 6.06 Replacement Torches
- 6.07 Options and Accessories
- APPENDIX I: CIRCUIT PROTECTION & WIRING
- APPENDIX II: QUICK DISCONNECT LEADS ASSIGNMENT
- APPENDIX III: REMOTE WIRING
- APPENDIX IV: OPERATIONAL FLOWCHART
- APPENDIX V: HOSE DIAGRAM
- APPENDIX VI: TORCH PARTS
- APPENDIX VII: TORCH PARTS TABLE
- APPENDIX VIII: SCHEMATIC DIAGRAM
- APPENDIX VIII: SCHEMATIC DIAGRAM