Tweco FP-165 Mini MIG Portable MIG Welder User Manual
Mini mig, Manual, Portable mig welder
Advertising
This manual is related to the following products:
Table of contents
Document Outline
- SECTION 1:SAFETY INSTRUCTIONS AND WARNINGS
- SECTION 2:INTRODUCTION
- SECTION 3:INSTALLATION
- 3.01 Location
- 3.02 Safety
- 3.03 Grounding
- 3.04 Electrical Input Requirements
- 3.05 Requirements for Maximum Output
- 3.06 Installation of Shielding Gas (GMAW) Process
- 3.07 Attaching the Gun and Cable Assembly to the Power Source
- 3.08 Polarity Changeover
- 3.09 Installing Wire Spool
- 3.10 Feedrolls
- 3.11 Install Wire into the Feedhead
- 3.12 Install Wire into the Welding Gun
- SECTION 4:OPERATION
- 4.01 General Safety Precautions
- 4.02 FirePower Controls
- 4.03 Gas Metal Arc Welding (GMAW)
- 4.04 Flux Cored Arc Welding (FCAW)
- 4.05 Shutdown Procedures
- 4.06 Basic Welding Technique
- 4.07 Welding Gun Positions
- 4.08 MIG Welding (GMAW) Variables
- 4.09 Establishing the Arc and Making Weld Beads
- 4.10 Pre-Weld Procedure
- 4.11 Welding Procedure
- 4.12 Reference Tables
- 4.13 FirePower 125 Welding Setting Selection Guide
- 4.14 FirePower 135 Welding Setting Selection Guide
- 4.15 FirePower 165 Welding Setting Selection Guide
- 4.16 Gas Selection for Gas Metal Arc Welding
- SECTION 5:SERVICE
- APPENDIX 1: OPTIONS AND ACCESSORIES
- APPENDIX 2: REPLACEMENT PARTS
- APPENDIX 3: FIREPOWER 125 SYSTEM SCHEMATIC
- APPENDIX 4: FIREPOWER 135 SYSTEM SCHEMATIC
- APPENDIX 5: FIREPOWER 165 SYSTEM SCHEMATIC
- LIMITED WARRANTY
- WARRANTY SCHEDULE
- GLOBAL CUSTOMER SERVICE CONTACT INFORMATION