Tweco Victor Thermal Dynamics Power Module Upgrade Kit - Manual (Page 2)

2 Manual 0-5326
Upgrade kit installation
NOTE
Most components not shown for clarity of installation. You will have to maneuver over, around and
through components to complete this installation. Disconnect all live power before starting procedure.
1. Remove side covers both the top and bottom on both sides of the machine.
Art # A-12323
2. Select appropriate blank center chassis plate(s) to be removed.
• for a 200A upgrade select just the center panel
• for a 300A or 400A upgrade select both the top and the middle
NOTE
For a 400A upgrade from a 300A system, the center inverter will have to be removed.
3. Remove the 4 screws holding in the panel and rock outward before pulling.
Art # A-12324