Setting the temperature, Reversing the door – CDA FF120 User Manual

Page 4

Advertising
background image

Setting the temperature

The temperature is regulated by the thermostat dial, found inside the fridge compartment on the right hand side.

The thermostat can be adjusted between 1 (least cold) and 5 (coldest).

To switch off the cooling system, turn the thermostat to 0.

Reversing the door

It is possible to reverse the door on this refrigerator, if required.

To do so, follow the steps below:

1. Carefully tilt the appliance to allow access to the base of the appliance.

2. Remove the height adjustable feet.

3. Remove the lower hinge plate.

4. Lift off the door and carefully put it to one side.

5. Remove the top hinge plate. Change the hinge pin on the plate over and then replace the hinge plate on the alternate

side of the door frame.

6. Remove the hinge pin receiver and blank at the top of the door and replace on the alternate side.

7. Relocate the door on the top hinge pin.

8. Refit the lower hinge plate.

9. Refit the height adjustable feet.


light bulb cover

thermostat

Advertising